MERIT INDUSTRIES Ion Rx Service Manual download pdf (Page 61)

15” Monitor Installation

1. If you will not be using the touchscreen from your original monitor, skip to step 3. If you will be

using the original touchscreen, clean the glass on the new LCD monitor with the supplied alcohol

wipe, then cut pieces of the supplied 1/2” foam tape long enough to cover each edge of the monitor

without overlapping. After the tape is in place on the monitor, peel off the backing.

2. Carefully place the touchscreen over the monitor in the same manner it was attached to the old

monitor, making sure the screen is properly and evenly aligned over the glass. Clean the front of

the touchscreen with the supplied alcohol wipe once it is in place.

3. Carefully slide the new monitor into the bezel, making certain that the white edge of the monitor

and the monitor wire connections are facing the bottom of the bezel. Ensure that the monitor is

properly centered, then tighten the hinge screws. See Figure 2.

NOTE: If you removed the joystick on your Elite Edge, carefully return the game to its side and

reconnect the joystick to the connector in the game. Place the protective bracket in its previous

position, sliding it under the lazy Susan and making sure the cutouts are placed around the installed

screws. Make sure all wires are secured inside the bracket, then reinstall the 2 screws securing

the bracket. Return the game to its upright position.

4. Install the supplied LCD mounting bracket and fasten it to the game with the 6 screws. One screw

(and washer) will fasten the strain relief cord, while another will secure the blue ground wire for the

key socket. See Figure 1.

5. Replace the key socket assembly by securing the bolt, green wire and nut over the LCD mounting

bracket. See Figure 1.

6. Connect the touchscreen controller cable to the touchscreen controller and secure it with a tie

wrap. Also restore the touchscreen controller cable ground wire. See Figure 1.

7. Connect the touchscreen power cable to the touchscreen controller (see Figure 1) and reconnect

the Molex connector (orange and gray wires).

8. Connect the LCD power connector (black and yellow wires). See Figure 2.

9. Reattach the OSD board to the Velcro on the back of the monitor, then connect the new OSD

cable to both the OSD board and the monitor. See Figure 1. Secure the cable in the twist clamp.

10. Connect the new VGA cable to both the monitor and the motherboard. Run the cable beneath the

I/O board mounting plate and secure it in place with the bracket and 2 screws. See Figure 3. Also

replace the ground wire.

Troubleshooting Information - Removal/Installation of Major Assemblies -

Ion eVo/eVo Wallette/Elite Edge

Megatouch Ion Technical Reference Manual

ATTENTION:

OBSERVE PRECAUTIONS FOR HANDLING ESD-SENSITIVE DEVICES

Removal/Installation of Major Assemblies -

Ion eVo/eVo Wallette/Elite Edge (cont’d)

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 207 208

No comments

MERIT INDUSTRIES Ion Rx Service Manual Page 61