MERIT INDUSTRIES Ion Rx Service Manual download pdf (Page 133)

ATTENTION:

OBSERVE PRECAUTIONS FOR HANDLING ESD-SENSITIVE DEVICES

Removal/Installation of Major Assemblies -

Ion Aurora

Troubleshooting Information - Removal/Installation of Major Assemblies -

Ion Aurora

Megatouch Ion Technical Reference Manual

Joystick Assembly Removal

1. Turn off and unplug the game.

2. Rest the game facedown to access the base. Protect and stabilize the front casing and monitor by

prepping the area with cardboard, foam, etc. Remove the two larger screws (one on each side)

that are securing the joystick assembly to the base. See Figure 1.

FIGURE 1 - SCREWS SECURING JOYSTICK ASSEMBLY TO BASE

JOYSTICK BOARD

CONNECTIONS

FIGURE 2 - JOYSTICK ASSEMBLY REMOVED FROM STANDARD AURORA

Joystick Assembly Installation

1. Reconnect the two connections to the joystick board and the two ground wire connections (on non-

Widescreen Auroras) to the new joystick assembly. See Figure 2. Turn the new joystick assembly

over and install it in the game.

2. Carefully lay the game monitor-side down and secure the joystick assembly to the base with 2

screws. See Figure 1.

3. Upright the game.

4. Plug in and turn on the game. Once the game has booted up, proceed to Troubleshooting Your

Touchscreen to calibrate the joystick.

3. Carefully upright the game and remove the joystick assembly. Turn the assembly over and remove

the two connections to the joystick board and the two ground wire connections (on non-Widescreen

Aurora systems). See Figure 2.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 207 208

No comments

MERIT INDUSTRIES Ion Rx Service Manual Page 133