MERIT INDUSTRIES Megatouch XL Owner's Manual download pdf (Page 5)

PM0182-01 MEGATOUCH™ XL SUPER 5000 MANUAL 3

the brightness and contrast can also correct for a

lack of sharpness in the picture.)

Maintenance

Cleaning the Cabinet

• The cabinet should be cleaned with a damp cloth

and mild detergent.

Cleaning the Touchscreen Monitor

• The touchscreen glass should be cleaned with a

damp cloth and isopropyl alcohol or a non-

ammonia cleanser. Do not use any abrasive or

vinegar-based cleansers, as they will damage the

touchscreen glass.

To gain access to the entire surface of the monitor

screen on the upright model, you will have to release

the monitor door latches. To do so, open the coin

mech door. Located inside, above and to the right and

left of the coin mech, are two monitor door latches.

Loosen the thumbscrews securing the latches and

rotate the latches to release the monitor door. See

Figure 11.

To gain access to the entire surface of the monitor

screen on the cabaret model, you will have to release

the monitor door latches. To do so, open the coin

mech door. Located inside, above and to the right and

left of the coin mech, are two monitor door slide-

latches. Loosen the thumb nuts securing the latch and

slide the latch open. Pull up on the bottom of the bezel

to remove it (NOTE: TO FULLY REMOVE THE

BEZEL, YOU MUST DISCONNECT THE GROUND

BRAID).

To gain access to the entire surface of the monitor

screen on the countertop model, you will have to

remove the top of the machine. To remove the top of

the machine, unlock and open the rear door.

Disconnect the fan power connector and disconnect

the plastic tubing and ground strap attached to the lid.

Press up on the spring-loaded levers located on each

side of the lid. Push the lid forward and pick it up to

remove. See the decal inside the lid for a diagram of

locations.

NOTE: DO NOT USE ANY ABRASIVE SOLVENTS, ACID OR

VINEGAR-BASED CLEANSERS ON THE MONITOR OR SIDE

DECALS. OVER TIME, SUCH CLEANSERS COULD HARM

THE TOUCHSCREEN AND ERASE THE DECALS. BE

CAREFUL NOT TO USE COMMERCIAL CLEANERS

CONTAINING ANY OF THESE SUBSTANCES.

Cleaning the Compact Disc and CD Player

• Clean the CD and CD player approximately every

90 days, or if you experience any problems with

the CD player.

• CD cleaning supplies can be purchased from your

local record store or audio supply house.

• To activate the game for use with a CD-ROM lens

cleaner, turn off the game and set DIP Switch 2-1

to “ON.” Turn on the game and follow the

instructions displayed on the screen.

Fan Operation

• To ensure proper operation of the game, it is

important that all fans are operating correctly and

that the airflow is unobstructed. Make sure nothing

is placed inside the cabinet or next to the fan

vents that would inhibit the flow of air. Also, if any

fans are not operating, it is important that they be

replaced.

Troubleshooting

Coin Jam

The game also has coin jam and stringing detection

software. Should a coin become jammed in the mech

or someone tries to string the mech, a continuous tone

will be emitted by the game and the words “COIN JAM”

will be displayed on the screen.

If the game emits the coin jam indicator sound when

powered up, this may indicate that the NORMALLY

CLOSED contacts of the coin mechanism are being

used. The NORMALLY OPEN contacts must be used.

Also, see the accompanying Troubleshooting Guide.

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comments to this Manuals

No comments

MERIT INDUSTRIES Megatouch XL Owner's Manual Page 5

Comments to this Manuals

Related products and manuals for Video games & consoles MERIT INDUSTRIES Megatouch XL